Reported by: ANTISHICNC Date: September 26, 2021
The normal use of the ordinary lathe must meet the following conditions: the power voltage fluctuation of the position where the machine tool is located is small, the ambient temperature is lower than 30 degrees, and the relative humidity is less than 80%. 1. Environmental requirements for mac...... [Read More]
Reported by: ANTISHICNC Date:
See the world of bearings from numbers Size from 2mm to 6m Bearings vary in size from small to large. The smallest “miniature bearing” in the world has an inner diameter of 0.6 mm × an outer diameter of 2.0 mm × a thickness of 0.8 mm, and is used in micro motors. The large bearing,...... [Read More]
Reported by: ANTISHICNC Date: September 24, 2021
1. Press the start button and the main motor does not rotate. Cause analysis: the main power switch is not turned on; The start button does not contact well, the contactor does not pull in, the wiring in the main motor junction box and electrical panel does not contact well or the connector fa...... [Read More]
Reported by: ANTISHICNC Date:
The main contents of the safety operation procedures for CNC drilling machines include: (1) Operators of CNC drilling machines shall comply with relevant regulations and requirements and shall not operate in violation of regulations. (2) Operators shall wear labor protection articles before wo...... [Read More]
Reported by: ANTISHICNC Date:
1. Operators shall be proficient in and master the performance and characteristics of CNC gantry drilling machine. Ensure that the emergency stop switch is always in the case of emergency, which can play a positive and effective role, so as to effectively reduce the incidence of accidents. 2. ...... [Read More]
Reported by: ANTISHICNC Date: September 23, 2021
After the acquisition of Mitsubishi Heavy Industries machine tools, Nidec plans to invest 80 billion yen to promote machine tool business growth Japanese media said that in order to expand its machine tool business, Nidec will invest in the two subsidiaries of Nidec Symposium and Nidec Machine...... [Read More]
Reported by: ANTISHICNC Date:
Ordinary turning tools are mainly used for rough and fine turning of the inner and outer surfaces and end faces of various parts, and reach the size, form and position tolerance accuracy and surface quality required by the drawing. Ordinary turning tools are classified according to the compact...... [Read More]
Reported by: ANTISHICNC Date:
Transformation of Positioning Exact Stop Function of Frequency Conversion Spindle of Multi-Gear CNC Lathe 01 Preface Among the economical ordinary CNC lathes, the most widely used is the high and low two-speed CNC lathe. This kind of CNC lathe can shift and change gears through the spindle box...... [Read More]
Reported by: ANTISHICNC Date:
The basic principle of locking the rocker drill column is that the operation of the main shaft of the rocker drill machine tool is the operation of the Du transmission system of the main shaft of the machine tool. The rocker drill gives the longitudinal feed of the operating shaft, and the roc...... [Read More]
Reported by: ANTISHICNC Date:
Problems related to bearing installation of radial drilling machine 1. The external force applied during the assembly of the radial drilling machine shall not be transmitted through the roller or ball of the bearing, so as to avoid damaging the bearing. 2. Non impact loading and unloading is p...... [Read More]
