Reported by: ANTISHICNC Date: September 27, 2021
1. Preface In the high-precision, high-quality, and high-efficiency processing of parts and components, measurement technology plays a very important role. Due to differences in the blanks, it is difficult to rely on the machine tool itself to control the machining accuracy. Real-time measurem...... [Read More]
Reported by: ANTISHICNC Date:
How does superstring finishing technology improve finishing efficiency? The purpose of CNC finishing is to ensure the final dimensional accuracy and surface quality of the workpiece. The surface quality of finishing depends largely on the height of the residual ridge left after processing. Th...... [Read More]
Reported by: ANTISHICNC Date:
1. What is mirror processing? The mirror surface processing system is a system for reshaping a rotating tool. By using a reshaped tool for processing, mirror surface processing can be achieved. Mirror processing can reduce polishing time and avoid the distortion of optical curved surfaces caus...... [Read More]
Reported by: ANTISHICNC Date:
The XYZ axis of the three axes. Processing has limitations. For example, blades cannot be processed; Five axis has all functions of three axes, xyzwb axis or xyzab; The workbench can rotate freely. For five axis machining, there must be a c-axis, that is, the rotating table, and then add an ax...... [Read More]
Reported by: ANTISHICNC Date:
Maintenance of CNC system 1. Strictly abide by the operating procedures and daily maintenance system 2. Prevent dust from entering the numerical control device: floating dust and metal powder are easy to cause the insulation resistance between components to drop, resulting in failure or even ...... [Read More]
Reported by: ANTISHICNC Date: September 26, 2021
1.Introduction Whether it is mining machinery or construction machinery, hydraulic cylinders can be seen everywhere as a key executive power component. When the hydraulic cylinder is working, the working medium (water, emulsion, oil, air, etc.) is injected into the hydraulic cylinder cavity th...... [Read More]
Reported by: ANTISHICNC Date:
Simply put, bearing clearance is the clearance (or interference) inside a single bearing or a system composed of several bearings. The clearance can be divided into axial clearance and radial clearance, which depends on the bearing type and measurement method. Why should the bearing clearance ...... [Read More]
Reported by: ANTISHICNC Date:
1. It is strictly prohibited for non staff to operate the machine tool. 2. it is strictly prohibited to touch the cutting tool, the rotating part of the machine tool or the rotating workpiece during operation. 3. Emergency stop is not allowed. In case of emergency, after stopping with this but...... [Read More]
Reported by: ANTISHICNC Date:
1. Inspection before start-up 1.1 add appropriate lubricating grease according to the lubrication chart of the machine tool. 1.2 check that the electrical facilities of each department, handles, transmission parts, protection and limit devices are complete, reliable and flexible. 1.3 all gears...... [Read More]
Reported by: ANTISHICNC Date:
The normal use of the ordinary lathe must meet the following conditions: the power voltage fluctuation of the position where the machine tool is located is small, the ambient temperature is lower than 30 degrees, and the relative humidity is less than 80%. 1. Environmental requirements for mac...... [Read More]
