Features: HY series fully automatic CNC high-speed metal circular sawing machine is mainly composed of machine bed, power head part, feed system, clamping device, hydraulic system, electrical system, spray cooling system, automatic lubrication system, screw chip conveyor, cutting It is compose...... [Read More]

What is the difference between a CNC milling machine and a machining center? In fact, this problem is not only confusing for laymen, but also many people in the industry are stupid and unclear. Simply put, the machining center is an upgraded version of the CNC milling machine. If the CNC milli...... [Read More]

With the development of computer technology, modern CNC offline diagnosis software is gradually being integrated with CNC control software, and some systems have introduced “expert systems” into fault diagnosis. This undoubtedly brings convenience to the maintenance and diagnosis o...... [Read More]

  The CNC lathe refers to the position accuracy achieved by each coordinate axis under the control of the CNC device. In the detection of the accuracy of the CNC lathe, the inverse error of the linear motion can be used for detection. The technicians of our company summarized this process...... [Read More]

The status quo of CNC surface grinders and main CNC systems Compared with lathes, milling machines, etc., surface grinders adopt numerical control systems later because of its special requirements for numerical control systems. In the past ten years, with the help of CNC technology, continuous...... [Read More]

Is the machining center good for hard rail or linear rail? Finally got it! What is a hard track? What is a linear track? The hard rail refers to a casting in which the guide rail and the bed are integrated, and then the guide rail is processed on the basis of the casting. That is, the shape of...... [Read More]

What should I do if the precision of the imported large-scale machining center changes? Look at the cause analysis and countermeasures Imported large-scale CNC machining centers are equipment imported by the country at a huge cost. They have the technical characteristics of high precision, rel...... [Read More]

There are not many introduction materials on surface grinder grinding steps. It should be noted that the steps can be ground from two directions, and the basis for choosing which side to cut the steps from is efficiency. If the same part is changed in one direction, the grinding efficiency wil...... [Read More]

The vertical milling machine is suitable for using various rod milling cutters, circular milling cutters, and angle milling cutters to mill planes, bevels, grooves, etc. The milling head can be adjusted ±45° clockwise and counterclockwise in the vertical plane, and it can feed automatically in...... [Read More]

ANTS CB series CNC lathe adopts an integral flat bed and 30° inclined bed saddle structure, compact structure, large rotating diameter, small footprint; large cutter head, small cutter interference. Equipped with a domestic numerical control system, it can process inner and outer cylinders, co...... [Read More]