The preservation and maintenance of vertical band saws have always been a key point to ensure the working efficiency of vertical band saws. When we do not use vertical band saws for a long time, we should pay more attention to their preservation.
What should be paid attention to for long-term storage of vertical band saws?
1. It should be parked in a dry room. If it has to be parked outdoors, a flat ground should be selected and covered with wooden boards. Cover it with a cover cloth after parking.
2. Before long-term storage, the machine must be maintained, damaged parts must be repaired, and it must be thoroughly cleaned to keep it in good technical condition.
3. The arrangement and layout of the parking lot should ensure that the entry and exit of any machine is not affected by other machines.
4. The fuel control lever of the band saw should be placed in the idle position, and each joystick should be placed in the neutral position.
5. Storage of the engine.
The above are the things that need to be paid attention to for long-term storage of vertical band saws. Don’t forget to protect the vertical band saw just because you don’t use it for a while.
What should be paid attention to when using a vertical band saw?
1. The vertical band saw must be cleaned, lubricated and maintained regularly, and the working status of each component must be observed;
2. Before sawing, check whether there are foreign objects in the cutting material, and remove them in time to prevent damage to the saw blade;
3. During the operation of the vertical band saw, it is not allowed to go near the transmission part of the vertical band saw to deal with the fault, and it must be stopped before it can be dealt with;
4. During the operation of the vertical band saw, no adjustment or repair can be made, and adjustment and repair must be made after stopping;
5. Frequently observe the sawing quality , if the saw blade has quality problems, it should be repaired and replaced in time;
6. The brake device of the vertical band saw machine should not be used during the operation of the saw machine. It can only be used after the power is turned off and the machine is stopped, otherwise accidental injuries may occur;
7. The steel should be sawed steadily. During operation, the feeding speed should be flexibly controlled according to the actual situation of the steel. Too much sawing will hit the saw blade and accelerate the blunting of the saw teeth;
8. Waste and sawdust are not allowed to be piled up near the vertical band saw machine;
9. During sawing, raise and lower the upper saw card at any time to prevent the sawed material from colliding with the upper saw card.
ANTISHI Vertical Metal Band Sawing Machine CV Series
Technical Parameter :
| MODEL | CV-2535 | CV-4070 | CV-5080 |
| Cutting Capacity (mm) | H:250 D:350
L:1000~6000 |
H:400 D:700
L:1000~6000 |
H:500 D:800
L:1000-6000 |
| Blade Size (mm) | 34×1.1 | 41×1.3 | 41×1.3 |
| Blade Speed (m/min) | 30/45/75 | 30/45/75 | 30/4575 |
| Motor Main (KW) | 3. 0(kw) | 5. 5(kw) | 7.5(kw) |
| Coolant Pump (KW) | 0.06(kw) | 0.06(kw) | .6(kw) |
Get The Required Product Quotation As Quickly As Possible
If possible, Given detailed request helps to gain better-matched customized solution. Thanks for your patience. your request will be responsed within 1 hours, kindly pay attention to your email please.